|
It is currently Fri 22. Nov 2024 20:04:51
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
Malc1
|
 Posted: Sun 16. Aug 2015 14:24:04 |
|
Joined: Thu 07. May 2015 22:33:47
Posts: 169
|
|
Addition setup help with reference to my other thread.
Is the correct setup procedure for this to have the throttle to be fully shut at 0 trim position on the transmitter or a - trim value below this?
My fully closed throttle trim position is currently -40.
I normally raise it a few points towards 0 to get the engine to idle.
Just wondering if I need to adjust my TX's throttle channel end points to give the 0 - 100 throttle in the software with the throttle trim at 0 and then use the governor min tab to fully reduce it further to close the throttle fully?
Just clarifying a basic setup point - to be sure.
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Sun 16. Aug 2015 19:49:42 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
It will work in both ways. There are no special requirements.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Malc1
|
Posted: Sun 16. Aug 2015 20:07:33 |
|
Joined: Thu 07. May 2015 22:33:47
Posts: 169
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 42 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
