| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Goblin 380 https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=794 |
Page 1 of 1 |
| Author: | Russell [ Mon 13. Jul 2015 13:24:08 ] |
| Post subject: | Goblin 380 |
Hi all. Setting up a G380 with BK servos all round I intend to run 2800 3000 3200 HS. Can anyone recommend a starting point for head & tail gain and piro comp. Thanks Russ |
|
| Author: | ZeXx86 [ Mon 13. Jul 2015 17:44:17 ] |
| Post subject: | Re: Goblin 380 |
Hi Russell, I recommend to start with default values, these are the best for the beginning. Piro Consistency should be somewhere between 160 - 175 depending on your tail setup. |
|
| Author: | Russell [ Tue 14. Jul 2015 9:58:46 ] |
| Post subject: | Re: Goblin 380 |
Thanks Tomas can you advise what the default settings are for the G380 I don't remember seeing a preset for this one to use as a starting point. |
|
| Author: | ZeXx86 [ Tue 14. Jul 2015 17:41:21 ] |
| Post subject: | Re: Goblin 380 |
Generally you do not need to change anything special from Default profile settings. Only Piro Consistency, Rudder Delay and Geometry 6° should be configured with respect to your model. If you can tell me what rudder servo do you use, I can tell you more accurate values. |
|
| Author: | SJo1 [ Tue 14. Jul 2015 20:56:58 ] |
| Post subject: | Re: Goblin 380 |
Russell is most probaply using BK 5005hv as tail servo. Or atleast I have it, as per manual show it too[WHITE SMILING FACE] |
|
| Author: | ZeXx86 [ Wed 15. Jul 2015 7:23:22 ] |
| Post subject: | Re: Goblin 380 |
Then the Rudder Delay can be configured to approx. value of 2. |
|
| Author: | Russell [ Wed 15. Jul 2015 10:41:08 ] |
| Post subject: | Re: Goblin 380 |
Yes Bk servos all round....I will try you suggestions. Thanks Guy's |
|
| Author: | Russell [ Thu 16. Jul 2015 10:12:45 ] |
| Post subject: | Re: Goblin 380 |
Running 2800 3000 3200. At 3000 the tail is perfect. Getting a slight wag at 2800 and 3200. I have inspected the tail and made it smoother next I will check gov gain and see if this helps. Russ |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|