| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Gov min/max range https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=702 |
Page 1 of 1 |
| Author: | scornflake [ Mon 01. Jun 2015 2:11:51 ] |
| Post subject: | Gov min/max range |
I'm having trouble setting up the gov for Nitro on an N7. Im using RJX as my throttle servo, FS0521HV. The problem is I cannot tune the Spirit to give me 0-100. If I get the min tuned so that it hits the low throttle stop on the engine, I can't get the max to hit the top throttle stop. The servo stops responding once there's a > 20 point adjustment. i.e: I can't tune min below -80 and I can't tune Max above 120. In trying to do so, there is no longer further movement/adjustment occurring at the servo. So far this means while I can adjust to get a correct zero/min throttle position, I can't get the high throttle set (it's quite a bit off, prob 5mm away at the carb itself). Should I just adjust end points to counter this? If I do that will that confuse the gov in the Spirit? |
|
| Author: | ZeXx86 [ Mon 01. Jun 2015 8:15:31 ] |
| Post subject: | Re: Gov min/max range |
Hi, you can change travel adjust in the transmitter freely. Then it should match fine. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|