| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Recommended Servo Arm Ball Distances https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=658 |
Page 1 of 1 |
| Author: | Malc1 [ Sat 09. May 2015 23:32:39 ] |
| Post subject: | Recommended Servo Arm Ball Distances |
Are there any recommended servo arm ball distances listed for this system? This would be for the cyclic and rudder servo's. Helicopter is a Gaui NX7 with MKS servo's. |
|
| Author: | ZeXx86 [ Sun 10. May 2015 9:07:52 ] |
| Post subject: | Re: Recommended Servo Arm Ball Distances |
There are no recomendations, but basically you can determine which distance is fine. If your rudder limits are too low, then the arm is too long. So then you can put shorter one. It should be approx. between 1/3 to 1/2 for the best performance. Similarly with the cyclic. Here you should check Geometry 6° value. Values of 128 and higher are fine. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|