|
It is currently Tue 01. Apr 2025 1:24:54
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
a20cae
|
 Posted: Tue 04. Mar 2025 14:43:42 |
|
Joined: Mon 02. Oct 2023 15:33:33
Posts: 11
|
|
Everything works fine tail holds swash all working in the correct direction.
software v3.6.2
When I lift off once in the air the heli flips volently to the right into the ground.
When I got the heli back to the house I noticed that if you lean the helicoter over (sytem live) it does not move the swash in the same direction as all my other spirit units.
I have reflashed the firmware, and reset the unit.
still does the same thing.
any ideas it all seams fine when plug into the PC.
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Tue 04. Mar 2025 21:38:28 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12587
|
|
Hello,
this problem is unfortunately caused by a wrong swashplate correction direction.
This can be caused by:
a) Wrong Mounting Position
b) Wrong Swashplate Type
c) Wrong Servo Wiring
d) Wrong Servo Reversing in the Servos tab
Or mix of all these 4 points.
So it is important to verify each and from then it should be all fine.
The most common is point c + d at the same time.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 8 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
