| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| NITRO SETUP https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=6305 |
Page 1 of 1 |
| Author: | raceboy1 [ Sun 29. Dec 2024 16:00:41 ] |
| Post subject: | NITRO SETUP |
I currently have four of my Heli's using Spirit GT But I ran into a problem in setting up one of my Nitro's that I use a switch to activate the Remote Glow from my Spektrum Transmitter I'm using SRLX I can't find a way to use one of the Aux Channels on the Spirt Gt FLB , for activating by a switch I know that in the function list there's an Output to Aux 2. I don't use Banks, so is there a way to re assign the Bank Channel The other way that I've found is using Channel 5 on my AR6610t receiver that I'm using. Which goes to INH when I setup my Gyro. But not sure if re assigning channel 5 would effect the gyro or not. |
|
| Author: | Mattes61 [ Sun 29. Dec 2024 20:19:42 ] |
| Post subject: | Re: NITRO SETUP |
Hello, if you want to use an Output to Ch 0 ord AUX2 you must activite throttel-channel in the Spirit to Channel 1 - I am not shure at the moment which channel you can activate that's what you have to test it, I believe it was ch0 but not shure - one channel works at 60hz at standard, like the throttlechannel 1 - If you don't actvate the throttle-channel the outputs will not work - Regards |
|
| Author: | ZeXx86 [ Mon 06. Jan 2025 8:40:27 ] |
| Post subject: | Re: NITRO SETUP |
Hello, in the General - Channels window you can set F: Output to AUX2 or CH0 function. This will output signal from selected channel to the Spirit port. It can be used for controlloing Glow Plug. I recommend to use AUX2 port for this purpose. CH0 might be running at too high frequency for your glow plug control electronics. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|