I am setting up a GT with Geolink 2 on the bench and had a few questions after reading the manual.

The manual says that the "F: Geo-Link Position Hold" function works similarly to "F: Coaxial." If so, why duplicate the function already found on the GT? What if any advantgae is obtained by programming "F: Geo-Link Position Hold"?

As far as interactions, how will the Heli respond if already in "F: Coaxial" mode and "F: Geo-Link Position Hold" is commanded?

Also, how will the Heli respond if "F: Stabilsation (Normal)" is active and "F: Geo-Link Position Hold" is commanded?

Just trying to understand all of this so I can make the good decisions on how to set this all up.