| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| YGE ESC connections to W1 -- what adapters are needed? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=6231 |
Page 1 of 1 |
| Author: | curmudgeon [ Tue 22. Oct 2024 19:49:11 ] |
| Post subject: | YGE ESC connections to W1 -- what adapters are needed? |
I am planning on placing an order for a WAVE radio and a few W1 units. I plan to use YGE "T" series ESCs. What adapter(s) do I need to order to connect the YGE ESCs to the W1 unit so I can both obtain YGE ESC telemetry data as well as be able to program and adjust YGE ESC parameters via the WAVE radio? |
|
| Author: | ZeXx86 [ Tue 22. Oct 2024 20:49:05 ] |
| Post subject: | Re: YGE ESC connections to W1 -- what adapters are needed? |
Hello, wiring is identical to other Spirit units: https://manual.spirit-system.com/index. ... _Telemetry Except that with all YGEs you can do a full setup directly from Wave. Also no throttle range settings is needed, it will set up automatically. |
|
| Author: | curmudgeon [ Tue 22. Oct 2024 21:47:24 ] |
| Post subject: | Re: YGE ESC connections to W1 -- what adapters are needed? |
Awesome!! I like that the YGE telemetry and programming will use just the small JST-XH side port of the W1 and not need to use a port on the servo power rail which I need for other components. This is very good news. Thank you. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|