Hello, I just ran a receiver RX7 update to version ghost 1.10.2. After the update, the receiver is no longer recognized by the transmitter. Can I do something about it? I have another recipient where the update ran and everything is fine, two W1s also did the update without any problems. I politely ask for help. Greetings Alex

Hello,

thank you for using our products.
You can perform recovery updating of the RX7 receiver directly from Spirit Settings software.
Do you have other Spirit unit or only W1 units? By connecting RX7 with Spirit unit you can perform updating over the cable as well even if connection to radio is not working.

It is very sad, however no dealer should ship package with Wave yet. They are not officially released yet and work is still going on. All dealers know that and should wait with the shipping.
If this happened, we are extremely sorry and recommend to wait until official release.

_________________
Spirit System developer

Thank you for your quick feedback. It is an RX7 receiver that no longer responds, i.e. not in a W1 frame. Can you tell me how to connect it to the PC. I have a spirit cable.

Hello,

please check our manual with updating procedure that you can use:
https://manual.spirit-system.com/index. ... X_Updating

You can perform the updating according section Updating with PC.
I hope this will help you.

If not, please contact me at private message and we will sort the issue.

_________________
Spirit System developer

Hello, Thank you very much with the instructions it worked wonderfully. I wasn't aware that I could switch to a secondary RX. Great service from you, thank you