|
It is currently Fri 22. Nov 2024 0:59:58
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
raceboy1
|
 Posted: Wed 05. Jun 2024 2:58:43 |
|
Joined: Thu 23. May 2024 23:36:16
Posts: 20
|
|
Getting real frustrated with this system, I’m switched this Heli from an Ikon
I have it all set up, but I can not get thru the Compass Calibration
The Firmware was flashed to Current
Here’s the process that I did
S elected set level Tab
Selected the Calibration Tab
Powered down the heli
Went outside
Repowered up the Heli with the transmitter
And at that point I get a solid Greed light on the GeoLink
The manual says I should get a rapid flashing Blue light
This never happens
So what is going on
|
|
| Top |
|
 |
|
10x
|
Posted: Wed 05. Jun 2024 8:17:26 |
|
Joined: Wed 04. Jul 2018 18:03:55
Posts: 180
|
|
Have you tried going out side without powering down the heli? Just a thought...
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Wed 05. Jun 2024 14:32:29 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hello,
rapid blue flashing on the GeoLink should be there only when moving with module.
In any case if you will power on the GeoLink for 3 times without successful callibration it will return back to previous calibration.
Then you have to click at the Calibration Request button again.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 36 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
