Spirit System
https://www.spirit-system.com/phpBB3/

Telemetry cable resistor for high voltage?
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=6070
Page 1 of 1

Author:  Schmarfield [ Sun 28. Apr 2024 14:12:16 ]
Post subject:  Telemetry cable resistor for high voltage?

The manual says to use a 10k Ohm resistor in the telemetry cable adapter (this is for Castle Creations), but says a different value may be needed above 7v if readings are unstable. If I’m going to run 8v BEC should I start with a different value?
Thank you.

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/