| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| setting up 6 degree pitch on wizard https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=6018 |
Page 1 of 1 |
| Author: | Pete678 [ Sun 03. Mar 2024 17:45:47 ] |
| Post subject: | setting up 6 degree pitch on wizard |
I've gone through and programmed all my servos into the unit and set all for zero degrees at middle stick and I have all the correct movement and stabilisation correction set but, when I come to set the 6 degree of pitch it goes into a negative pitch, but if I move the blade to the side 90 degrees to the boom it is perfect at 6 degrees. I know in the wizard it says to do it parallel to the boom but like I say it comes at a negative pitch. The only thing I can think of is that I may have mixed up the pitch and aileron servo the wrong way maybe? Any help would be great. .Thanks |
|
| Author: | ExCCHP [ Sun 03. Mar 2024 21:52:59 ] |
| Post subject: | Re: setting up 6 degree pitch on wizard |
Are you measuring the blade Over the tail boom or the blade in the front? I believe you are to use the blade over the front of the heli for All measuring. |
|
| Author: | Pete678 [ Sun 03. Mar 2024 22:24:42 ] |
| Post subject: | Re: setting up 6 degree pitch on wizard |
I've set a couple up before and I always do the measuring over the front and then make sure the rear is the same for mechanical purposes. I get negative pitch when it goes into the 6 degree set up mode. Haven't had it before do that's why I think I ,may need to go through the wizard again and switch ail and ele around and configure from there |
|
| Author: | senaka [ Mon 04. Mar 2024 9:36:32 ] |
| Post subject: | Re: setting up 6 degree pitch on wizard |
I would redo the wizard by first setting it back to factory defaults, and taking it from there. |
|
| Author: | ZeXx86 [ Mon 04. Mar 2024 9:39:45 ] |
| Post subject: | Re: setting up 6 degree pitch on wizard |
Hello, it might not indicate any issue. At the front you could get negative but at the rear it will be positive. It depends at which side you are measuring. |
|
| Author: | Pete678 [ Mon 04. Mar 2024 11:05:39 ] |
| Post subject: | Re: setting up 6 degree pitch on wizard |
so If I measure at the back and get 6 degrees then it will be fine as all the functions work as they should? Thanks |
|
| Author: | ZeXx86 [ Mon 04. Mar 2024 11:12:02 ] |
| Post subject: | Re: setting up 6 degree pitch on wizard |
Yes, correct. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|