|
It is currently Fri 22. Nov 2024 13:00:43
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
davidbitton
|
 Posted: Mon 18. Sep 2023 14:23:58 |
|
Joined: Fri 25. Aug 2023 2:35:51
Posts: 2
|
|
The three Torq BLS2208 servos I have attached to my Spirit GTR are not starting in the position setup during subtrim adjustment. Also, the servos are not holding up the blades. The servos setup in the correct position w/o blades installed. I even upped the BEC voltage to 8.0; thinking it was a torque issue. Nope. Any ideas? Thanks!
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Tue 19. Sep 2023 14:51:08 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hello,
I guess that settings were not saved after your servo setup. For this reason position changed.
Please make sure that settings are saved in the Backup tab by clicking at the Save button.
Or you can enable Automatic saving at the bottom side of the software.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 52 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
