| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Additional servo for retracts | Micro Spirit | Blade 230 https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5796 |
Page 1 of 1 |
| Author: | 3D3D3D [ Fri 25. Aug 2023 6:23:27 ] | ||
| Post subject: | Additional servo for retracts | Micro Spirit | Blade 230 | ||
On the Blade 230 Helicopter (with Spektrum DSMX Satelite) I have all channels occupied except for the Rudd channel. I installed the ESC on the AUX channel as per the instructions and the signal line for the rear motor on channel 4 (I think). Now I need an extra servo for a retractable landing gear. Can I use the Rudd channel on the micro spirit for this? Thanks in advance Best Regards
|
|||
| Author: | Mattes61 [ Fri 25. Aug 2023 21:28:58 ] |
| Post subject: | Re: Additional servo for retracts | Micro Spirit | Blade 230 |
Hello, in my opinion is this not possible - the GT for example has the possybility for Output at channel 0 or Aux2 you see that in spirit settings in channel/function there is no possibility to Output to RUD ! Regards |
|
| Author: | 3D3D3D [ Sat 26. Aug 2023 4:10:52 ] |
| Post subject: | Re: Additional servo for retracts | Micro Spirit | Blade 230 |
Mattes61 wrote: Hello, in my opinion is this not possible - the GT for example has the possybility for Output at channel 0 or Aux2 you see that in spirit settings in channel/function there is no possibility to Output to RUD ! Regards Thanks for your feedback! I also think that it is not possible.. But I still hope that it is somehow possible.. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|