| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Altitude Hold and Throttle Curve https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5680 |
Page 1 of 1 |
| Author: | MichaelT1960 [ Thu 25. May 2023 12:07:10 ] |
| Post subject: | Altitude Hold and Throttle Curve |
When you engage altitude hold do you also need a constant (gov mode) throttle curve so that low stick is not off? Otherwise you would be in trouble at lower stick. |
|
| Author: | franz88 [ Thu 25. May 2023 14:26:04 ] |
| Post subject: | Re: Altitude Hold and Throttle Curve |
the governor it just works from 51% of throttle curve to the 100% throttle curve. indeed if you go GENERAL-GOVERNOR-SETTINGS you will see that request rpm it is activated only from 51% onwards. from 50% to 0% the governor is deactivated |
|
| Author: | MichaelT1960 [ Thu 25. May 2023 15:03:22 ] |
| Post subject: | Re: Altitude Hold and Throttle Curve |
What if I am using my own governor curve on my Futaba T18szh transmitter? Do I need to make sure it it is flat from 0 to 100, or does the Spirit 2 automatically take care of that? Thank you, Michael |
|
| Author: | vvv850 [ Thu 25. May 2023 15:15:28 ] |
| Post subject: | Re: Altitude Hold and Throttle Curve |
Please go through the governor setup page to better understand the concept: https://manual.spirit-system.com/index. ... e=Governor You will need a FLAT curve above 50%. A flat curve means ex 60% 60% 60% 60% 60% |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|