| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Spirit GT problem - won't initialise after update to 3.5.0 https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5662 |
Page 1 of 1 |
| Author: | Helipilot [ Fri 12. May 2023 1:01:01 ] |
| Post subject: | Spirit GT problem - won't initialise after update to 3.5.0 |
I have a Spirit GT which I think was running 3.4.1 firmware. I was having issues where the unit appeared to initialise but I could not move servos using transmitter. After several attempts powering off system and repowering unit everything worked fine. I was concerned so I tried to update software and firmware to 3.5.0 Update reported successful with a solid blue led on Spirit GT but Software will no longer connect to Spirit GT. Repowering unit results in blue flashing led and no communication. I have tried recovery mode several times but still not working. How do I get my unit working again? thanks |
|
| Author: | ZeXx86 [ Fri 12. May 2023 8:24:46 ] |
| Post subject: | Re: Spirit GT problem - won't initialise after update to 3.5 |
Hello, could you send me .spirit-flash.cfg file from your Documents directory please? I will send you instructions how to fix the problem to a private message. Thank you |
|
| Author: | Helipilot [ Fri 12. May 2023 8:54:52 ] |
| Post subject: | Re: Spirit GT problem - won't initialise after update to 3.5 |
Thanks for prompt response. Unfortunately I do not have a .spirit-flash.cfg in my documents folder. Regards Alan |
|
| Author: | ZeXx86 [ Fri 12. May 2023 9:00:18 ] |
| Post subject: | Re: Spirit GT problem - won't initialise after update to 3.5 |
Do you have a spirit paper box? There is serial number written there. We will need it if possible. Could you also send your IPv4 address to a private message? We will assign special firmware there which should resolve the issue. You can find it at this page: https://whatismyipaddress.com/ |
|
| Author: | Helipilot [ Fri 12. May 2023 9:28:09 ] |
| Post subject: | Re: Spirit GT problem - won't initialise after update to 3.5 |
PM Sent thanks Alan |
|
| Author: | Helipilot [ Fri 12. May 2023 17:34:40 ] |
| Post subject: | Re: Spirit GT problem - won't initialise after update to 3.5 |
Thanks for the special firmware. It almost worked. I've sent details of the issue via PM thanks Alan |
|
| Author: | Helipilot [ Fri 12. May 2023 23:47:03 ] |
| Post subject: | Re: Spirit GT problem - won't initialise after update to 3.5 |
Thanks again for the excellent troubleshooting support. Everything appears to be working as it should now. It turns out I had a defective BEC cable. Regards Alan |
|
| Author: | franz88 [ Wed 17. May 2023 14:31:41 ] |
| Post subject: | Re: Spirit GT problem - won't initialise after update to 3.5 |
yesterday I updated one spirit gt at 3.5.0 and everything worked for me |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|