Hello,
first from all there are 3 different ways how you can activate Rescue or Stabilisation modes.
You selected one that require negative gyro gain to activate rescue.
If you make it simplified then you can set:
1. Stabi/Function - Selected by Channel
2. Set F: Rescue (Automatic) in the Channels window to a free channel - for example Channel 7.
Nothing else is needed. But you can keep Gyro Gain method. There is no difference in Rescue behavior.
You have to keep switch in this position if you still want to have Rescue (Automatic) active.
When function is engaged, it will work. When you will change switch position, it will be always OFF.
After model will ascend for 1.5 seconds this rescue will work all the time, until it is switched OFF by assigned switch.
Behavior is fully described here:
https://manual.spirit-system.com/index. ... (Automatic)
