| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Wobbles & Jerks https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5457 |
Page 1 of 1 |
| Author: | Trondyne [ Sat 05. Nov 2022 2:20:57 ] |
| Post subject: | Wobbles & Jerks |
I'm still trying to solve these issues running a uSpirit on a Blade 230S that has an extended tail and larger rotor blades (270mm)... Have searched though this forum for various settings and so far no luck... She jerks (yaw) and wobbles (roll) ... Now the battery is slightly larger than stock and is mounted lower than stock, under the ship in between the main gear making the CG lower than stock... I want to send my settings in for analysis, how do I get the Spirit settings for emailing? Would appreciate help finally getting rid of these issues... Thanks |
|
| Author: | Mattes61 [ Sat 05. Nov 2022 12:20:03 ] |
| Post subject: | Re: Wobbles & Jerks |
Hello Trondyne, I can only help you how to backup your settings from Spirit Settings to your harddisk - Attachment: Backup_the settings.jpg [ 122.81 KiB | Viewed 348 times ] Attachment: Save profile.jpg [ 131.05 KiB | Viewed 348 times ] enter a name for your profile and save it - then simply upload the file here in the forum - that's actually it - Attachment: Upload file.jpg [ 159.18 KiB | Viewed 348 times ] Regards Mattes61 |
|
| Author: | Trondyne [ Sat 05. Nov 2022 22:42:05 ] |
| Post subject: | Re: Wobbles & Jerks |
Ok thanks I wasn't sure if the developer used those files to inspect settings on units with issues... Thanks |
|
| Author: | Mattes61 [ Sun 06. Nov 2022 14:57:02 ] |
| Post subject: | Re: Wobbles & Jerks |
Hello Trondyne, the developer is here in the forum and also downloads the files from here, he will certainly be able to help you - there may also be users here who have converted the 230S to Spirit FBL - Regards Mattes61 |
|
| Author: | Uplate [ Mon 14. Nov 2022 23:11:03 ] |
| Post subject: | Re: Wobbles & Jerks |
I had a similar issue. It was a bad servo. Looked fine on a servo tester, but just idle on the bench I could see it moving without TX input. Changed out servo and problem solved. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|