| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Geolink, what is the difference using stability modes? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5282 |
Page 1 of 1 |
| Author: | Bernhard.F [ Fri 08. Jul 2022 11:51:08 ] |
| Post subject: | Geolink, what is the difference using stability modes? |
Hi, When I want to set up "Position hold", "Return to home" and "Auto landing" I read that I should activate the Stabi Mode Coaxial also. Is it really needed What is the difference in using the stability normal and the coaxial mode. I found no description regarding the difference in behaviour and if it is really needed. Best Regards Bernhard |
|
| Author: | ZeXx86 [ Fri 08. Jul 2022 11:58:17 ] |
| Post subject: | Re: Geolink, what is the difference using stability modes? |
Hello, you can see it all in manual here: http://manual.spirit-system.com/index.p ... on_(Normal) http://manual.spirit-system.com/index.p ... tion_(Acro) http://manual.spirit-system.com/index.php?title=Coaxial And here is short description: http://manual.spirit-system.com/index.p ... #STABI_TAB If you engage GeoLink functions directly by channel then it does not matter what is configured as Stabi Function. On the other hand it is not that hard to just try the funciton in the air. You can use momentary switch to make it perfectly safe. |
|
| Author: | Bernhard.F [ Fri 08. Jul 2022 12:27:43 ] |
| Post subject: | Re: Geolink, what is the difference using stability modes? |
Thank a lot for the fast answer! It helps me for configuration in advance. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|