Spirit System
https://www.spirit-system.com/phpBB3/

FW 3.4 Channel Direct asigantion not work with Futaba Sbus
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5231		 Page 1 of 1
Author:  Dr.Fleming [ Thu 02. Jun 2022 14:47:03 ]
Post subject:  FW 3.4 Channel Direct asigantion not work with Futaba Sbus
FW 3.4 Channel Direct asignation not work with Futaba Sbus, and missing Anty gravity mode on channel list. :cry:
Author:  ZeXx86 [ Thu 02. Jun 2022 14:50:00 ]
Post subject:  Re: FW 3.4 Channel Direct asigantion not work with Futaba Sb
Hello,

it works with all radios, there is no difference for unit what radio or receiver you are using until you have enough channels.
It mean that something is configured incorrectly. We will finish our manual to make it more clear in following days.

You can attach your configuration so I can check it.
Author:  Dr.Fleming [ Thu 02. Jun 2022 15:32:13 ]
Post subject:  Re: FW 3.4 Channel Direct asigantion not work with Futaba Sb
Thanks for quick answer, also I see on the channel windows,the green moves when I activate the Rescue normal,
but nothing happen, I try disconnecting the Stabi, but the same. But as usually works wit Stabi Funktion :roll:



ZeXx86 wrote:
Hello,

it works with all radios, there is no difference for unit what radio or receiver you are using until you have enough channels.
It mean that something is configured incorrectly. We will finish our manual to make it more clear in following days.

You can attach your configuration so I can check it.
Author:  ZeXx86 [ Thu 02. Jun 2022 16:01:44 ]
Post subject:  Re: FW 3.4 Channel Direct asigantion not work with Futaba Sb
You have to set Selected by Channel in the Stabi tab as Function.
Author:  ZeXx86 [ Sat 04. Jun 2022 9:32:46 ]
Post subject:  Re: FW 3.4 Channel Direct asigantion not work with Futaba Sb
Was problem resolved by setting Function to Selected by Channel?
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/