Hi all,
I am using a BLHeli S ESC connected on Aux 1 to the Spirit Unit. I have on my radio (TX16s - Edge TX 2.6) on a 3 way switch my throttle settings. 1. Position : Idle up Low
2. Position: Idle up high
3. Position : Poti sets the throttle level.
I see in the diagnostic tab that the throttle setting in the Spirit unit is received correctly. Depending on how I programm my radio the right throttle value arrives.
However, the ESC and Motor spinns up to full speed if the throttle value on my curves is higher than 1500us. No matter if 1501 or 1900us its always full throttle. If it's below 1500 I get something like half throttle and even then it doesnt matter if 1100 ir 1499us. Always the same head speed.
On the govenor page I see that the desired RPM goes to the correct values, but I don't see any reading from the ESC. I guess with PWM is a one way signal.
The rotor is slowing spooling up, so the settings in general must be right.
If I switch to the 3rd position with the poti, the Heli goes almost immediatly to the desired head speed without slow spooling up.
What could cause that?
Michael
| Attachments: |
|
gov.png [ 28.53 KiB | Viewed 581 times ] |