| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Wizard setup https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4964 |
Page 1 of 1 |
| Author: | KaltBaron20 [ Thu 11. Nov 2021 3:52:07 ] |
| Post subject: | Wizard setup |
Question for support. Once the gyro setup is completed via wizard, to achieve maximum pitch of 10 degrees and minimum of -1degrees....will adjustments to linkages effect the 6 degrees geometry setup |
|
| Author: | ZeXx86 [ Thu 11. Nov 2021 9:30:28 ] |
| Post subject: | Re: Wizard setup |
Yes, it will affect everything and is not recommended. Instead you should use settings in your radio to set pitch from +/- 10° to 10/-1°. So adjusting pitch curve is the only correct solution. |
|
| Author: | KaltBaron20 [ Tue 16. Nov 2021 4:17:44 ] |
| Post subject: | Re: Wizard setup |
ZeXx86 wrote: Yes, it will affect everything and is not recommended. Wow..good I asked. As I fly scale I prefer a linear curve -1 or 0 to 10 degrees. Thanks for the reply.
Instead you should use settings in your radio to set pitch from +/- 10° to 10/-1°. So adjusting pitch curve is the only correct solution. |
|
| Author: | KaltBaron20 [ Tue 16. Nov 2021 6:00:33 ] |
| Post subject: | Re: Wizard setup |
KaltBaron20 wrote: ZeXx86 wrote: Yes, it will affect everything and is not recommended. Wow..good I asked. As I fly scale I prefer a linear curve -1 or 0 to 10 degrees. Thanks for the reply.Instead you should use settings in your radio to set pitch from +/- 10° to 10/-1°. So adjusting pitch curve is the only correct solution. So there is no way a linear pitch curve from 0-10 and linear throttle curve 0 -100 can be achieved via the spirit 2 system ?? Is that correct ?? |
|
| Author: | ZeXx86 [ Tue 16. Nov 2021 8:35:48 ] |
| Post subject: | Re: Wizard setup |
Yes, there is way that I described in the previous post. Simply set pitch curve from 0 - 100% to achieve pitch range from 0° to 10° - instead of -100% to 100% for +/- 10°. But initially mechanics must be set for full range. So that when servos are in the center position, there must be 0° between main blades. Any other settings will lead to imprecision. This is common for all FBL units. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|