From manual
Sent from my SM-G991U using Tapatalk
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| [SOLVED] Nitro governor issue https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4929 |
Page 1 of 1 |
| Author: | GScott [ Tue 12. Oct 2021 1:30:29 ] |
| Post subject: | [SOLVED] Nitro governor issue |
I just finished a Nitron build and the governor is either not working or seriously over speeding. Today was the first flights and I started hovering in normal which has a curve of 0-25-40-50-65. I switched to idle 1 which is supposed to be 2000 and the RPM display showed over 2400. I don’t have a tach but it was well north of 2000. I am using the Spartan sensor split so that the signal goes to the middle pin of the RPM input and the power/ground go to aux 2. I’m using 2 active magnets and the sensor divider set to 2 with a max RPM of 2200. The curve is a flat 91. I moved everything from a Kraken 580n with the only change being the use of 2 active magnets. The log is clean as far as I could tell but I didn’t check until I got home not realizing Spirit clears the log on power up unlike Vbar that keeps it. I verified the sensor shows “inactive” over both magnets. I’m using a new GT with a Jeti Rex 7. The throttle goes to channel 1 on the Jeti rx which I believe is the same way it was setup on the Kraken but I’m not 100% positive. I’m out of ideas at this point. |
|
| Author: | luke457 [ Tue 12. Oct 2021 1:35:24 ] |
| Post subject: | Re: Nitro governor issue |
The throttle servo has to be connected to the GT, otherwise the GT can not control the throttle. Sent from my SM-G991U using Tapatalk |
|
| Author: | luke457 [ Tue 12. Oct 2021 1:43:46 ] |
| Post subject: | Re: Nitro governor issue |
From manual Sent from my SM-G991U using Tapatalk |
|
| Author: | GScott [ Tue 12. Oct 2021 15:48:17 ] |
| Post subject: | Re: Nitro governor issue |
Thanks, that fixed it. |
|
| Author: | luke457 [ Tue 12. Oct 2021 16:41:30 ] |
| Post subject: | Re: Nitro governor issue |
GScott wrote: Thanks, that fixed it. You're very welcome! Sent from my SM-G991U using Tapatalk |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|