| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Engaging Stability Modes - new user observation https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4831 |
Page 1 of 1 |
| Author: | Helipilot [ Mon 16. Aug 2021 2:08:03 ] |
| Post subject: | Engaging Stability Modes - new user observation |
My model configuration is as follows :- Helicopter: Trex 500L Dominator Transmitter: Jumper T16 Pro (Open TX) Receiver: FrSky D8R-II ACCST with Telemetry (PWM) FBL: Spirit GT with Geolink Receiver channel mapping Throttle unassigned Aileron 2. channel Elevator 3. channel Rudder 4. channel Gyro Gain 5. channel Pitch 6. channel Bank 7. channel Stabi configuration Bank 0 disabled Bank 1 coaxial Bank 2 rescue normal (enabled with negative gyro gain) Tail Gyro configuration Position 0 -50 (gyro normal) Position 1 50 (heading hold) Position 2 60 (heading hold) I have discovered that coaxial and rescue modes will only work correctly if the gyro channel is set to a negative value. I knew that a negative gyro value was required to allow rescue mode to work but did not realise that a negative gyro value was required to allow stability modes to work. I can get around the issue by programming a channel 5 overide mix in the transmitter to ensure that the gyro channel is set to -50 whenever I engage bank 1 or bank 2. Is my observation correct or have I made an error in the way I have configured my system? Thanks for your support Alan |
|
| Author: | ZeXx86 [ Mon 16. Aug 2021 7:53:24 ] |
| Post subject: | Re: Engaging Stability Modes - new user observation |
Hello, your observation is perfect. Here you can see full description of how it can be configured: http://manual.spirit-system.com/index.p ... Stabi_mode You can also assign dedicated channel instead setting of a negative gyro gain. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|