Spirit System
https://www.spirit-system.com/phpBB3/

Can I use FrSky's Inverted F.Port port?
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4813		 Page 1 of 1
Author:  xoexoe [ Fri 06. Aug 2021 4:41:00 ]
Post subject:  Can I use FrSky's Inverted F.Port port?
I already wired up my Archer RS to use the Inverted S.Bus/F.Port port with Brain2/Ikon2. Now I want to use the same receiver to try out the Spirit GT. Do I need to resolder to the S.Bus port?

Image

Image

Attachments:
Screen Shot 2021-08-05 at 8.16.31 PM.png
Screen Shot 2021-08-05 at 8.16.31 PM.png [ 29.49 KiB | Viewed 371 times ]
Screen Shot 2021-08-05 at 8.36.20 PM.png
Screen Shot 2021-08-05 at 8.36.20 PM.png [ 256.26 KiB | Viewed 371 times ]
Author:  Ahmad.Kassem [ Fri 06. Aug 2021 4:45:52 ]
Post subject:  Re: Spirit GT, Pressure Sensor not working
Resolder the wire to the third pin (sbus) and flash fport FW and you are good to go

Sent from my SM-N976Q using Tapatalk
Author:  Ahmad.Kassem [ Fri 06. Aug 2021 4:46:17 ]
Post subject:  Re: Can I use FrSky's Inverted F.Port port?
Sorry sport

Sent from my SM-N976Q using Tapatalk
Author:  xoexoe [ Fri 06. Aug 2021 6:23:01 ]
Post subject:  Re: Can I use FrSky's Inverted F.Port port?
I want to use F.Port. And I believe there’s no flashing required Archer RS because you can switch protocols from the TX via ACCESS
Author:  ZeXx86 [ Fri 06. Aug 2021 13:18:12 ]
Post subject:  Re: Can I use FrSky's Inverted F.Port port?
Hello,

you will need normal/stock wiring of the receiver.
Author:  xoexoe [ Fri 06. Aug 2021 13:52:46 ]
Post subject:  Re: Can I use FrSky's Inverted F.Port port?
Thank you.
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/