Hi First post and new to spirit
I’ve had around 12 flights on my GT now and setup with everything pretty much default except rudder rate (11). I have enabled stabilisation acro on a momentary switch, purely as a safety blanket while trying some new stuff.
Anyway onto the scary moment , I let a “very”competent pilot fly my model at the weekend and the first 3mins were bliss.. however he started to perform some piro tic tocs and suddenly he felt he had no control and that the model had applied negative pitch, the model was at around 30-40ft and he hit hold as it had started to fly over our heads and fortunately he managed to gain control and place the model gently on the deck.
Now in the 12 flights I’ve had I’ve felt completely at ease and don’t throw the model around as hard as he was, is it possible that vibration has caused this ?
I’m really reluctant to fly it now as I’m apprehensive that it will do the same to me?
The spirit gt is mounted on rigid mount on supplied tape on an electric RAW , HW 200 currently no telemetry connected ( waiting on cable) running a Futaba 7008SB , throttle to ch3 on receiver and sb2 to rudder on the GT… couple of lads at the field suggested that sbus 2 was the cause and it should be connected via sbus.
From what I could see in the logs there where no anomalies, all servos hold position under stall, no wires chaffed.
Please Help!!!
