Spirit System
https://www.spirit-system.com/phpBB3/

[SOLVED] Spirit 2 not initilizing in 3.3.1 after upgrade
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4775		 Page 1 of 1
Author:  Jojo [ Sun 18. Jul 2021 11:22:54 ]
Post subject:  [SOLVED] Spirit 2 not initilizing in 3.3.1 after upgrade
Hi,

I have upgraded firmware on my Spirit 2 with latest and it doesn't anymore start up normally.
Goes into Blue Led blinking mode and i can't anymore connect via USB nor via Jeti TX.

Only if i flash again same firmware it works, but if power off Spirit , it doesn't initiate when i power it up.

Tried the old firmware but same issue, i have never had this issue with any spirit modules.

Can i get help to fix this?
Author:  ZeXx86 [ Mon 19. Jul 2021 7:51:43 ]
Post subject:  Re: Spirit 2 not initilizing right in 3.3.1 after upgrade
Hello,

please send .spirit-flash.cfg file to a private message or our email. With this file we will be able to fix the problem.
I will send you all instructions.
Author:  Jojo [ Mon 19. Jul 2021 12:05:35 ]
Post subject:  Re: Spirit 2 not initilizing right in 3.3.1 after upgrade
Thanks
Its sent via PM

ZeXx86 wrote:
Hello,

please send .spirit-flash.cfg file to a private message or our email. With this file we will be able to fix the problem.
I will send you all instructions.
Author:  Moki38 [ Tue 31. Aug 2021 8:55:03 ]
Post subject:  Re: Spirit 2 not initilizing right in 3.3.1 after upgrade
Same here, Same Spirit2, Same firmware, same result -> Bricked Spirit2

Did a search for the file (.spirit-flash.cfg), can't find it..(W10).
But i have multiple units, does it get overwritten?
Author:  ZeXx86 [ Wed 01. Sep 2021 9:00:54 ]
Post subject:  Re: Spirit 2 not initilizing right in 3.3.1 after upgrade
The issue was resolved after our private conversation with special firmware. We recommend to use the latest Spirit Settings for updating the units.
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/