| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| How to connect YGE 90HV to Spirit RS? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4723 |
Page 1 of 1 |
| Author: | DanielB80 [ Fri 25. Jun 2021 22:32:21 ] |
| Post subject: | How to connect YGE 90HV to Spirit RS? |
Hello, I want install a Spirit 2 on my TDR with an old YGE 90HV. On the Wiki I saw that I have to connect the RPM Signal line to the RPM Pin but where I have to connect the brown/orange (they both are connected with each other) wire? Can I connect them to EXT Pin? Is there a possibility to connect the RPM signal to the Spirit RS that I can use the RPM signal to display on my JETI DS-14II main screen? |
|
| Author: | DanielB80 [ Sun 27. Jun 2021 22:02:31 ] |
| Post subject: | Re: How to connect YGE 90HV to Spirit RS? |
Nobody have an idea? |
|
| Author: | latjo-k [ Mon 28. Jun 2021 8:23:12 ] |
| Post subject: | Re: How to connect YGE 90HV to Spirit RS? |
Hi It is the red cable from esc program (rpm)going to the rpm pin on spirit,the brown cable is going to - on some pin on fbl,dasent matter whitsh -pin you choses.The orange is for yge progcard. Then you can see the rpm in Jeti tx telemetry. I think you looking at the connection for Vbar,its different from Spirit. //Latjo |
|
| Author: | DanielB80 [ Mon 28. Jun 2021 12:20:30 ] |
| Post subject: | Re: How to connect YGE 90HV to Spirit RS? |
Thank you, so I can connect the brown (ground) cable to the EXT Pin under the RPM Pin! |
|
| Author: | latjo-k [ Mon 28. Jun 2021 13:18:19 ] |
| Post subject: | Re: How to connect YGE 90HV to Spirit RS? |
DanielB80 wrote: Thank you, so I can connect the brown (ground) cable to the EXT Pin under the RPM Pin! No this pin is for jeti sensors,the E1 port -pin or anyone else exept for sys port can you use. You can allso connect the -(ground)to the becs- or if you use a 2s battery to -pole,the - ground is the same in the whole system. //Latjo |
|
| Author: | DanielB80 [ Mon 28. Jun 2021 14:03:13 ] |
| Post subject: | Re: How to connect YGE 90HV to Spirit RS? |
Thanks for the answer, I thought that EXT Pin I can not use, this was my general question here! I will use one of the ground from the satellite ports, this I don't need, the rest is totally used because of external BEC and I don't want to use a V-Cable Adapter. |
|
| Author: | latjo-k [ Mon 28. Jun 2021 16:03:21 ] |
| Post subject: | Re: How to connect YGE 90HV to Spirit RS? |
OK Your Welcome |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|