| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Spirit Governor Setup https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4600 |
Page 1 of 1 |
| Author: | Harleyflyer1000 [ Mon 15. Mar 2021 2:51:58 ] |
| Post subject: | Spirit Governor Setup |
I have a question the Spirit 2 governor setup. I hooked up a fresh lipo and did some test head speed runs without blades on a Goblin 380 Buddy helicopter. I set the max head speed in Spirit at 3700 and my throttle curve for Normal, Stunt 1 and Stunt 2 as 70%, 75% and 80%, respectively. When I ran my head speed test, the Spirt app indicated a Requested RPM of Normal at 2579, Stunt 1 at 2764, and Stunt 2 at 2949. However, the max current speed it would get to was about 2,170 or so and that Current RPM did not change between Normal, Stunt 1 and Stunt 2. The Request RPMs would change when I would switch between them but not the actual RPMs. I’m assuming this is because the current RPMs could not reach the minimum requested speed I had set. Any ideas on why the current RPMs will not even reach 2200 rpms? I was using a fresh fully charged 6s 2200 lipo. I would appreciate any suggestions. Thanks in advance! Keith |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|