Hello,
today i went out to make first tests with my T-Rex 550 with Spirit RS and Geolink.
Before and after this, i´ve controlled all switch effects / funktions with the Spirit Software.
All channels and functions run as programmed respectively indicators show coorect switching.
These functions are:
- Altitude Limit
- Position and altitude hold
- Return to home
First i make a few circles in order to warm up after winter...everithing ok.
Sure, the blue light at the geolink burns steady and as i told all functiuns and switches have been tested multiple times
wit the Spirit Software.
Than i decide to activate altitude Limit - set to 5 m abover ground . I simply stop steering at about 10m in a nearly horizontal Position and let the heli slowly fall by himself...nothing happens.
If i did´nt intervene i believe the Heli would touch ground.
Where is the mistake ?
Second i decide to test position and altitude Hold which ar combined at one switch.
Once again i lift the heli about 15 m and stop steering i in a nearly horizontal position, then i activated position and altitude hold. Nothing happens, the heli drifts away with the wind and climbs or descends,
no effect visible. I tested it several times and let him go more and more to see that anything happens. But nothing happens...
Where is the mistake ?
Because of this i didn´t test Return to home.
But i ask myself why nothing happens respectively why does nothing takes a visible effect ?
Do i have to activate a stabilizatiom mode in order to make it work ?