|
It is currently Mon 25. Nov 2024 10:03:02
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 5 posts ] |
|
| Author |
Message |
|
Socal
|
 Posted: Fri 30. Jan 2015 18:08:21 |
|
Joined: Fri 30. Jan 2015 17:57:20
Posts: 3
|
|
Hello,
Have a question on setting up rescue on DX-9 3 position switch on Trex 500. Have Acro enabled with 70% on position 0 and -70 on position 2 for rescue. Not sure what if anything I need to do to middle position 1? In diagnostic tab shows position 0 as HL, position 1 as HL, and position 2 as HF? Does this sound right?
Thank you all for your help in advance!!
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Fri 30. Jan 2015 18:22:16 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hello,
welcome in our forum!
I recommend to set Gyro gain for position 1 too, because then, there will be 0% gain, so the rudder wont hold at all.
You can set same gyro gain as for position 0.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Socal
|
Posted: Fri 30. Jan 2015 20:32:33 |
|
Joined: Fri 30. Jan 2015 17:57:20
Posts: 3
|
|
Great forum!
Is there a way to set that gain? I only have travel adjust for hi and low?
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Fri 30. Jan 2015 22:13:46 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
You can check this thread: viewtopic.php?f=20&t=448Actually the result you want is probably very same.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Socal
|
Posted: Sat 31. Jan 2015 0:24:23 |
|
Joined: Fri 30. Jan 2015 17:57:20
Posts: 3
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 5 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
