| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Spirit RS Governor https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4546 |
Page 1 of 1 |
| Author: | gerry [ Tue 16. Feb 2021 20:14:46 ] |
| Post subject: | Spirit RS Governor |
Hello Tomas, I use the internal governor with the Spirit Rs and am also very satisfied with the settings. The only thing that bothers me a bit is the torque in the first second when running up, which starts with a jolt, the rest of the run-up time then fits again. Is there a way to dampen the first jolt a bit? FW 3.2.2. Greetings from Gernot |
|
| Author: | Habásek [ Tue 16. Feb 2021 20:26:53 ] |
| Post subject: | Re: Spirit RS Governor |
Fine-Tuning – Spoolup rate Configure speed of the motor spoolup. For initial tests we recommend Slow spoolup rate. Fine-Tuning – Spoolup Rampup Value that will be added at the beginning of motor spoolup – when Hold is turned off. If the spoolup is not smooth, i.e. motor will start with a kick, the value is too high. If the spoolup has a delay, the value is too low. Default value of 50 μs should work fine in the most cases. http://manual.spirit-system.com/index.php?title=Governor |
|
| Author: | gerry [ Tue 16. Feb 2021 20:39:55 ] |
| Post subject: | Re: Spirit RS Gouverneur |
Hello habasek. Thank you for your quick reply. I will deal with the two values in more detail. And adjust it even more finely. Everything else is going perfectly, I am very satisfied. Greetings Gernot |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|