| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Question about scale Setup 6° https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4534 |
Page 1 of 1 |
| Author: | maddi67 [ Tue 09. Feb 2021 16:12:10 ] |
| Post subject: | Question about scale Setup 6° |
Hello, how do you recommend to make the 6 degrees optimation for scale helicopters ? Is it the best way to start with 0° Pitch when Stick is centered and run the 6° Procedure and make the Positive and negative limits with the Pitch curve after that ? Thx Martin |
|
| Author: | ferdey [ Tue 09. Feb 2021 20:53:49 ] |
| Post subject: | Re: Question about scale Setup 6° |
The 6° setup is for cyclic pitch, not collective pitch. Put one blade straight out over the nose and at 0 degrees collective pitch, use full left or right aileron. Adjust the tuning value under the 6° checkbox until you get 6°. I made an edit, I forgot how it was done myself without looking at the software 
|
|
| Author: | maddi67 [ Wed 10. Feb 2021 11:56:47 ] |
| Post subject: | Re: Question about scale Setup 6° |
Ok thank you, but i meant cyclic...sorry. If i adjusted my positive and negative values for scale flying ( ~-4 ....+11° collective), how can i adjust the cyclic 6° ? Is it ok to drive the blades into the 0° position with collective pitch stick and then do the 6° procedure ? Or is ist better to do this wit symmetric collectiv pitch - for example -10°...+10° and adjust the collective limits afterwards...? Or is it the same in effect ? |
|
| Author: | ZeXx86 [ Wed 10. Feb 2021 13:43:02 ] |
| Post subject: | Re: Question about scale Setup 6° |
Hello, Geometry 6° setting is independent from any radio configuration. Stick input is not involved at all. So Collective Pitch settings also does not matter in this case. |
|
| Author: | maddi67 [ Wed 10. Feb 2021 14:14:41 ] |
| Post subject: | Re: Question about scale Setup 6° |
ok, thank you ! |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|