|
It is currently Sun 24. Nov 2024 3:35:43
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
Tord J
|
 Posted: Sun 07. Feb 2021 19:10:15 |
|
Joined: Sat 28. Apr 2018 19:45:46
Posts: 7
|
|
I'm going to reset the gyro to factory settings.
The gyro is seated so that it is difficult to take in and out the cables.
Is it possible to reprogram the gyro with the servos connected without the servos breaking?
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Sun 07. Feb 2021 20:02:17 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
If your servos are all 1520 then nothing wrong should happen.
In the worst case it is enough to unplug Rudder.
Or at least tail servo arm.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Tord J
|
Posted: Sun 07. Feb 2021 20:33:45 |
|
Joined: Sat 28. Apr 2018 19:45:46
Posts: 7
|
|
Ok
I should be able to disconnect the tail rudder.
Thanks..
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 55 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
