| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Rescue setup on 3 position switch https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=451 |
Page 1 of 1 |
| Author: | Socal [ Fri 30. Jan 2015 18:08:21 ] |
| Post subject: | Rescue setup on 3 position switch |
Hello, Have a question on setting up rescue on DX-9 3 position switch on Trex 500. Have Acro enabled with 70% on position 0 and -70 on position 2 for rescue. Not sure what if anything I need to do to middle position 1? In diagnostic tab shows position 0 as HL, position 1 as HL, and position 2 as HF? Does this sound right? Thank you all for your help in advance!! |
|
| Author: | ZeXx86 [ Fri 30. Jan 2015 18:22:16 ] |
| Post subject: | Re: Rescue setup on 3 position switch |
Hello, welcome in our forum! I recommend to set Gyro gain for position 1 too, because then, there will be 0% gain, so the rudder wont hold at all. You can set same gyro gain as for position 0. |
|
| Author: | Socal [ Fri 30. Jan 2015 20:32:33 ] |
| Post subject: | Re: Rescue setup on 3 position switch |
Great forum! Is there a way to set that gain? I only have travel adjust for hi and low? |
|
| Author: | ZeXx86 [ Fri 30. Jan 2015 22:13:46 ] |
| Post subject: | Re: Rescue setup on 3 position switch |
You can check this thread: viewtopic.php?f=20&t=448 Actually the result you want is probably very same. |
|
| Author: | Socal [ Sat 31. Jan 2015 0:24:23 ] |
| Post subject: | Re: Rescue setup on 3 position switch |
Thank you. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|