| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Help with Spirit RS/JETI/Nitro Gov Setup https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4470 |
Page 1 of 1 |
| Author: | smokin3000gt [ Sun 03. Jan 2021 21:38:26 ] |
| Post subject: | Help with Spirit RS/JETI/Nitro Gov Setup |
Hello, I have Spirit RS on my 580 Kraken Nitro On the maiden flight I had the Gov 'enabled' in my transmitter, and set my 3 flight modes [THROTTLE CURVES] Normal: Linear Idle 1: 70 flat Idle 2: 85 flat TH HOLD is 9% (idle) In regular flight there is no difference in RPM when changing between Normal/Idle 1/Idle 2. When doing a negative pitch pump, motor revs down uncomfortably close to a stall. Can anyone assist? This is the first Nitro with Spirit and also JETI. Thank you |
|
| Author: | ZeXx86 [ Mon 04. Jan 2021 8:47:23 ] |
| Post subject: | Re: Help with Spirit RS/JETI/Nitro Gov Setup |
Hello, I do not recommend to use Linear throttle curve, instead spoolup with Governor engaged. This should make it smooth and everything should work I hope. |
|
| Author: | SirSpanksAlot [ Tue 26. Jan 2021 14:45:51 ] |
| Post subject: | Re: Help with Spirit RS/JETI/Nitro Gov Setup |
in the above scenario where he is wanting a linear throttle curve for normal mode and a flat throttle curve with governor for his idle up modes would it work better if he also had bank switching on his flight mode switch? then have Gov off on normal mode with a linear throttle curve and have gov turn on with the other banks and flat throttle curves. Would this work or will he have to set all his flight modes to flat curves in order for the governor to work? |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|