| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| [SOLVED] Telme cable for JIVE PRO - longer version? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4435 |
Page 1 of 1 |
| Author: | cswhiting63 [ Sat 12. Dec 2020 15:45:02 ] |
| Post subject: | [SOLVED] Telme cable for JIVE PRO - longer version? |
I am retrofitting my Goblin 500 I upgraded to the JIve Pro for the telemetry but the FBL and the ESC are set about 2" too short for the TELME I have it working but its I cant screw down the FBL carbon seat so it wont do. Any way I can order one 3-4" bigger so I can have some play and not worry about it breaking in flight? thanks Charles |
|
| Author: | buttles [ Sat 12. Dec 2020 18:10:34 ] |
| Post subject: | Re: TELME CABLE FOR JIVE PRO CAN WE GET A LONGER VERSION? |
It's only a two core cable, I spliced a section into it to extend. Decent solder joint and you won't have a problem |
|
| Author: | ZeXx86 [ Mon 14. Dec 2020 11:52:44 ] |
| Post subject: | Re: TELME CABLE FOR JIVE PRO CAN WE GET A LONGER VERSION? |
It is enough to write the request to order message. Then if possible, we will produce longer cable. |
|
| Author: | cswhiting63 [ Tue 15. Dec 2020 5:58:02 ] |
| Post subject: | Re: TELME CABLE FOR JIVE PRO CAN WE GET A LONGER VERSION? |
Thanks I would like a longer cable will do order request I could try the solder solution I just saw your caution on making your own which Im not great at thanks |
|
| Author: | cswhiting63 [ Tue 12. Jan 2021 3:05:45 ] |
| Post subject: | Re: [SOLVED] Telme cable for JIVE PRO - longer version? |
So I did lengthen the cable had a dsx2 cable used the wires and soldered extension on but Im not getting Telem Im using telme selection kontronik JIVE pro is 1.14 version and im on 3.21 have a dx-18 which is 1.2 and a Spektrum 4651 RX with the spirit cable SLXR2 cable connected correctly? I saw that I should have a Txt gen option on #2 in telem on DX-18 to do the field integration I don't see that option as I roll thru the choices? Any idea on what I should do the cable was soldered correctly and heat shrinked in middle same end adapters as from Spirit just 3" longer due to positioning of spirit2 and Jive -pro. Any help would be appreciated would love to have integration and Telem options working THX |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|