Spirit System
https://www.spirit-system.com/phpBB3/

Tail Servo doesn´t work corrrect
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=443		 Page 1 of 1
Author:  Voodoo2 [ Sun 25. Jan 2015 18:46:16 ]
Post subject:  Tail Servo doesn´t work corrrect
Hallo,

today I try to adjust my sprit. The tail servo (rudder) is on CH4. The diagnotic shows me +-118% but if I move the stick the servo makes only 4mm way.

I tested a other channal an the servo makes the hole way. Its a BLS954. Frequenz is 1520 and 333.

Does anyone have an idea?

Regards Jens
Author:  ZeXx86 [ Sun 25. Jan 2015 18:56:47 ]
Post subject:  Re: Tail Servo doesn´t work corrrect
Try to set Head Lock mode, your gyro is most probably in Normal/Rate mode.
You can just set Gyro gain so the diagnostics will show HL instead of N.
Author:  Voodoo2 [ Sun 25. Jan 2015 19:08:30 ]
Post subject:  Re: Tail Servo doesn´t work corrrect
Ok I raise the gain and the servo starts work correctly :D

Now I have the problem that CH4 is not CH4 in my Radio control. I used a DS16 with Jeti Rsat.

The servo display show me the channels for example CH3 Pitch. If I change CH3 in the Spirit Sotware to Pitch it doesnt work. :?
Author:  ZeXx86 [ Sun 25. Jan 2015 19:09:46 ]
Post subject:  Re: Tail Servo doesn´t work corrrect
Great.

This is not a problem. Channel numbering is different between each transmitter/receiver.
It should work with defaults settings.
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/