Hi,
I fail to understand how this tab should be setup Rudder ESC - range (tunning)
What I do:
1. Existing values from the manual
Attachment:
1.png [ 3.21 KiB | Viewed 190 times ]
1. I tick the checkbox
2. motor starts idle at low speed
3. once I click any slider motor starts spinning at full speed.
4. at this point already have less than 5 seconds to act since this can burn the motor/esc
5. I quickly move the left side slider to get any feedback from the motor
6. from multiple tries I figured out that motor stops at ~200 value.
7. any other value does no change - motor spins at full speed
Can I get some hints if this works correctly or do I miss some steps?