Spirit System
https://www.spirit-system.com/phpBB3/

Spirit-RS: Geolink not detected in transmitter or desktop ap
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4294		 Page 1 of 1
Author:  deftguru [ Sun 20. Sep 2020 16:22:10 ]
Post subject:  Spirit-RS: Geolink not detected in transmitter or desktop ap
Hello!

Unfortunately, my Geolink is not detected. Geolink is connected to SAT1 of Spirit-RS unit. Within a 15-20 sec upon boot up Geolink is solid blue. When I connect USB cable to SYS-port on Spirit-RS and startup Spirit Software, then open General (Geolink Module is enabled). After I click Settings it says: "Link: Not connected". Note that the light on Geolink is still on (see attached photos).

What should I do? How can I get my Spirit unit to be recognized? Let me know if any additional information is required.

What I have tried:
1. I tried to flash the Geolink (even though it was not detected) using geolink-fw-1.2.0.4dg in both regular and recovery mode. However, both attempts failed as the Geolink unit was not detected.


My Setup: w/ Spirit-RS on firmware: 3.1.0
Cyclic: 3xDS-3001HV
Tail: 1xDS5005HV
Motor: Xnova 3215-930
ESC: Castle Lite 75 w/ 10am BEC
Geolink Serial: 5d-1d-d3-dc-04 (if that will help)
Attachment:
File comment: Geolink
Screen Shot 2020-09-20 at 11.17.30 AM.png
Screen Shot 2020-09-20 at 11.17.30 AM.png [ 246.57 KiB | Viewed 123 times ]


Attachments:
IMG_4149.jpg
IMG_4149.jpg [ 678.3 KiB | Viewed 90 times ]
IMG_4148.jpg
IMG_4148.jpg [ 644.52 KiB | Viewed 90 times ]
Author:  buttles [ Sun 20. Sep 2020 17:24:36 ]
Post subject:  Re: Spirit-RS: Geolink not detected in transmitter or deskto
Geolink goes into Sat 2 on the RS. In the manual.......
Author:  ZeXx86 [ Sun 20. Sep 2020 18:47:59 ]
Post subject:  Re: Spirit-RS: Geolink not detected in transmitter or deskto
Yes, all described in the manual :)
See attachment.

Attachments:
geolink-wiring.png
geolink-wiring.png [ 41.44 KiB | Viewed 77 times ]
Author:  deftguru [ Sun 20. Sep 2020 18:55:59 ]
Post subject:  Re: Spirit-RS: Geolink not detected in transmitter or deskto
Oh-god! Forgive me! I did not realize there was sat2! :) I saw it, but I was soo excited I plugged it without double-checking! Thanks all for the quick reactivity. The unit has been updated to the latest firmware and I am now playing around like a kid in a candy shop!
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/