Spirit System
https://www.spirit-system.com/phpBB3/

[SOLVED] Serious FBL Spririt RS Problems with my Kraken 570
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4292		 Page 1 of 1
Author:  schmeckm [ Sun 20. Sep 2020 10:10:55 ]
Post subject:  [SOLVED] Serious FBL Spririt RS Problems with my Kraken 570
Dear ALL,

I bought directly after you have launched the SPIRIT RS with the Jeti Receiver included. This week I included the RS into my new Goblin 570 Kraken but I have some serious issues. Yesterday I wanted to do my maiden flight and I have the following issues. It was good that my Heli was on ground and in the pre-flightcheck mode.

Issue 1: If I connect the battery to boot up the FBL there is no sound raised “Receiver connected” like by the normal other Jeti Receivers.If I switch off the transmitter, the Heli goes in Failure safe mode and into the positions I have defined in the FBL Software.  If I switch on the transmitter again the sound is coming,“Receiver connected”Why is this not coming up when booting up the Heli?

Issue 2: It seems that Basic Telemetry data are also not transmitted such as signal strengths like by my other Jeti Receivers? Why is this not transmitted? I thought it was a normal Jeti receiver included.

Issue 3: If I boot up my Heli and build up connection to the battery, sometimes I have the serious behavior that the Heli is not reacting anymore although he was normally booted. It occurs after 1-2 min after booting the FBL.  After FBL Boot up I can move all my sticks for the pre-flight checks, but after a while the Heli goes like in Failure safety mode and is not reacting anymore. I can see that the Heli is still fully powered up and Ic an see that all Servos are fully powered For me, issue 3 is a serious issue.

Have someone faced similar issues?

The entire Heli Setup was quite expensive.

I will not take the risk to fly with all those issues. 

Markus 
Author:  ZeXx86 [ Sun 20. Sep 2020 13:27:40 ]
Post subject:  Re: Serious FBL Spririt RS Problems with my Kraken 570 and D
Please disconnect everything from E2 port. Then it will work all OK.

Probably you have some telemetry sensor there. This is wrong with Spirit RS.
Author:  schmeckm [ Mon 21. Sep 2020 17:13:24 ]
Post subject:  Re: Serious FBL Spririt RS Problems with my Kraken 570 and D
Hi ALL
Yes thanks. Unfortunately this was the root cause of issue. I connected the Telemetry cable from my YGE Brunchless controller directly with the Port E2.
I have overseen it in the Docu-WIKI that this Channel can not be used.

It seems now its working fine, I'm l'm also getting a sound feedback message that the receiver is connected as expected.


Thanks, Markus
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/