Spirit System
https://www.spirit-system.com/phpBB3/

[SOLVED] Question to Spirit 2 and SRXL2-Protocol
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4255
Page 1 of 1

Author:  Mattes61 [ Mon 31. Aug 2020 12:41:45 ]
Post subject:  [SOLVED] Question to Spirit 2 and SRXL2-Protocol

Hello,

I got an new Spirit2 some days ago and I want to take the SPM4651T (SRXL2 satellite receiver) to setup the FBL - I have an question about the gyro-channel-reverse, that was said in the News about the new firmware 3.10 - by the way the FBL has this actual firmware - What I don't understand is, that I shall reverse the gyro-channel, because in the diagnostic-tab the gyro-channel works for -100 as rate mode and from 0 - 100 as headinghold-mode, I have not reversed the gyro-channel till yet. I think if I see in the diagnostic-tab the right information it shoult work ? In which cases is the channel-reverse necessary, only from upgrade from fimware below 3.10 ?

Attachment:
hardcopy_News_Firmware 3.10.jpg
hardcopy_News_Firmware 3.10.jpg [ 40.59 KiB | Viewed 153 times ]


Thanks for your answers !

Best regards
Matthias

My parts: DX18 Gen 1 (Airware 2.05) , Spirit2 (firmware 3.10), SRXL2 satellite receiver SPM4651T

Author:  ZeXx86 [ Mon 31. Aug 2020 12:45:18 ]
Post subject:  Re: Question to Spirit 2 and SRXL2-Protocol

Hello,

no reverse is needed with 3.1.0. With previous version it was needed.

So as you can see in the ChangeLog if you are using default settings in your radio, it will work.

Author:  Mattes61 [ Mon 31. Aug 2020 12:49:35 ]
Post subject:  Re: Question to Spirit 2 and SRXL2-Protocol

Thanks a lot for your fast answer !
By the way the firmware 3.10 works very well on all my helicopters, well done !

Best regards
Matthias

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/