Spirit System
https://www.spirit-system.com/phpBB3/

[SOLVED] 6610T + 4651T using SRXL2 and IX12
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4209		 Page 1 of 1
Author:  Pking [ Tue 11. Aug 2020 14:21:12 ]
Post subject:  [SOLVED] 6610T + 4651T using SRXL2 and IX12
I have a Spirit 2 with a YGE with Telemetry turned on. I have used this configuration with a DX9 and was working well with 9 channels. Now i am moving to a IX12.

The 6610T is connected to the Spirit2 using 3pin Port1 (instead of 3 PIN SRXLport on the side) and the 4651T is connected to the 6610T using the 4 wire min connector.

I switched to my IX12:
When i select channel 11 and 12, i can’t control these 2 channels. They stay at 0 versus going to +100 and -100. Is they’re something that i am doing wrong ?

I tried to make sure all the other channels available in the screen may be mixed up with no success.

Here is a picture of the Spirit interface you can see channel 11 is at 0:
Image


Thanks
Author:  LogoX2 [ Tue 11. Aug 2020 20:58:38 ]
Post subject:  Re: 6610T + 4651T using SRXL2 and IX12
Make sure your radio is set for 22ms. You can only use 10 channels with 11ms frame rate.
Author:  Pking [ Tue 11. Aug 2020 21:40:53 ]
Post subject:  Re: 6610T + 4651T using SRXL2 and IX12
LogoX2 wrote:
Make sure your radio is set for 22ms. You can only use 10 channels with 11ms frame rate.
Thanks LogoX2. Setting at 22 ms works !

I must say i have learned a lot with the SRXL2 modules.
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/