| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Master and Slave from Kosmik 200 to the Spirit? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=417 |
Page 1 of 1 |
| Author: | Franky13 [ Thu 08. Jan 2015 11:29:27 ] |
| Post subject: | Master and Slave from Kosmik 200 to the Spirit? |
Hello! How do I connect best master and slave from Kosmik 200 to the Spirit? As a receiver, I have the Jeti RSat2. There I've only PPM and Ext. Connector for telemetry. Thank You! Greetings Frank |
|
| Author: | taosgraveyard [ Thu 08. Jan 2015 15:17:38 ] |
| Post subject: | Re: Master and Slave from Kosmik 200 to the Spirit? |
Franky13 wrote: Hello! How do I connect best master and slave from Kosmik 200 to the Spirit? As a receiver, I have the Jeti RSat2. There I've only PPM and Ext. Connector for telemetry. Thank You! Greetings Frank You can wire one of your servos into a short y connector and plug the slave into the other end of the Y Or you could do the same with the PPM lead from the RX |
|
| Author: | Franky13 [ Thu 08. Jan 2015 16:07:27 ] |
| Post subject: | Re: Master and Slave from Kosmik 200 to the Spirit? |
OK, So I put a y-cable in ppm from the RSat2. then the plug from a y-cable to slave from Kosmik, the other plug from the y-cable to RUD on Spirit ... And the master cable from Kosmik to AUX from the spirit ... is that correct? |
|
| Author: | ZeXx86 [ Thu 08. Jan 2015 16:42:31 ] |
| Post subject: | Re: Master and Slave from Kosmik 200 to the Spirit? |
RUD - Y-cable: - PPM - BEC SLAVE AUX - THRO, BEC MASTER This could be the best solution with one Y-cable. But be sure Y-cable can handle such current (approx 10A). |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|