| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Kontronik TelMe settings in ESC https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4097 |
Page 1 of 1 |
| Author: | buttles [ Fri 26. Jun 2020 13:06:33 ] |
| Post subject: | Kontronik TelMe settings in ESC |
I have searched, promise! Just need to confirm the progunit settings in the Kosmik and Jive Pro.... Is it Motor Poles 2 and ratio of 1.0:1? I know the Spirit needs the correct details entered. Thanks |
|
| Author: | ZeXx86 [ Fri 26. Jun 2020 13:41:01 ] |
| Post subject: | Re: Kontronik TelMe settings in ESC |
Hello, yes. This is default settings and should work well. |
|
| Author: | buttles [ Fri 26. Jun 2020 15:13:26 ] |
| Post subject: | Re: Kontronik TelMe settings in ESC |
Thanks Tomas, thought so!! |
|
| Author: | azaz44 [ Fri 26. Jun 2020 17:58:51 ] |
| Post subject: | Re: Kontronik TelMe settings in ESC |
Just wondering, why not set it properly? In Kosmik you will then get the right RPM in the log files. |
|
| Author: | buttles [ Fri 26. Jun 2020 22:02:28 ] |
| Post subject: | Re: Kontronik TelMe settings in ESC |
'Cos in Jeti Data Analyser you get the same Telemetry will work properly as well |
|
| Author: | buttles [ Tue 30. Jun 2020 15:48:28 ] |
| Post subject: | Re: Kontronik TelMe settings in ESC |
Is there a reason the Spirit Telme to Jeti doesn't include BEC voltage from Kontronik ESCs? It's rather an important bit?!! Back to jLog otherwise... |
|
| Author: | buttles [ Wed 01. Jul 2020 19:56:30 ] |
| Post subject: | Re: Kontronik TelMe settings in ESC |
azaz44 wrote: Just wondering, why not set it properly? In Kosmik you will then get the right RPM in the log files. Kontronik Device Explorer has entries for divider and pole count so basic info into it can be shown correctly |
|
| Author: | azaz44 [ Thu 02. Jul 2020 13:28:51 ] |
| Post subject: | Re: Kontronik TelMe settings in ESC |
buttles wrote: azaz44 wrote: Just wondering, why not set it properly? In Kosmik you will then get the right RPM in the log files. Kontronik Device Explorer has entries for divider and pole count so basic info into it can be shown correctly Ok, that makes sense. This removes the need to reconfigure the Kontronik when you change gearing. I didn't notice that in Kontronik data explorer, but will check next time I use it. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|