| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| [SOLVED] full cyclic at 40% input https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3929 |
Page 1 of 1 |
| Author: | Armin [ Fri 01. May 2020 22:00:11 ] |
| Post subject: | [SOLVED] full cyclic at 40% input |
Hi, just setup my spirit system. Even without any Dual-Rate configured in Graupner MX-16 Tx and in the Diagnostic Tab 100% in both directions on Roll and Nick I reach the final roll/nick rate at approx. 40% input at the stick (same in the diagnostic tab) --> I can only see movement of the servos in the range of -40% to +40%. If I reduce Dual-rate to 50% in Tx same max cyclic pitch rates can be reached, but reaction seems slower. Pitch works fine from -100% to +100% with continuous movement. Is this a normal behavior? Especially that max cyclic is reached at 40% input seems incorrect for me. Any ideas? Thanks, Armin |
|
| Author: | enied [ Sat 02. May 2020 4:20:21 ] |
| Post subject: | Re: full cyclic at 40% input |
This is normal. BR Eugen |
|
| Author: | Armin [ Wed 06. May 2020 7:45:49 ] |
| Post subject: | Re: full cyclic at 40% input |
Thanks Eugen! Everything works fine! Armin |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|