|
It is currently Sun 24. Nov 2024 15:35:53
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
trondgzi
|
 Posted: Sun 26. Apr 2020 11:07:45 |
|
Joined: Sun 26. Apr 2020 10:56:40
Posts: 2
|
|
Hi! Can the inverted S.PORT pin be used for OpenTX integration? The manual says to never connect power to SYS, but will it work with inverted S.PORT signal and ground only?
|
|
| Top |
|
 |
|
p.i.engineer
|
Posted: Mon 27. Apr 2020 15:35:29 |
|
Joined: Tue 03. Jul 2018 18:54:25
Posts: 21
|
|
He'd need to allow half duplex for that to work.
the sys connector is TX, RX, G. So it's full duplex.
I tried a few months ago to put a diode on the tx pin so it wouldn't receive the messages from inverted s.port, but it didn't work.
| Attachments: |
Annotation 2020-04-27 073450.jpg [ 79.55 KiB | Viewed 225 times ]
|
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Mon 27. Apr 2020 21:33:39 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hi,
in theory it can be used. S.PORT is always running in half duplex mode. But wiring must be correct. VCC can't be connected there.
I can help only with unmodified S.PORT wiring.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: mainstreet and 60 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
