| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Tip over on spoolup https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3889 |
Page 1 of 1 |
| Author: | jjuk [ Sun 19. Apr 2020 17:49:33 ] |
| Post subject: | Tip over on spoolup |
I updated to 2.8.0 and enabled the governor. The heli was flying fine on 2.7.1. After the 1st time I replaced the servo arms that snapped (designed to do that), and did a full head setup. Everything was level. Setup was correct. Started spoolup and after 4-5 seconds it suddenly rips to the right. Repaired it, re-did swash levelling etc and tried again. Exact same thing. Rolls to the right. 3 times now. I cant get off the ground. Heli was initialised on a flat level surface. What's causing this? |
|
| Author: | andy6409 [ Sun 19. Apr 2020 18:59:46 ] |
| Post subject: | Re: Tip over on spoolup |
Have you got any trim or subtrim in your transmitter |
|
| Author: | ZeXx86 [ Sun 19. Apr 2020 19:08:17 ] |
| Post subject: | Re: Tip over on spoolup |
Hello, unfortunately it look like you have possibly plugged servo connectors incorrectly - CH1 to CH3, CH3 to CH1 or servo reverses are incorrect. Alternatively Position or Swashplate type. Before spoolup swashplate should be level, so moving with sticks is not good idea - this could cause tip over if you are moving with sticks during spoolup. |
|
| Author: | jjuk [ Wed 22. Apr 2020 11:35:00 ] |
| Post subject: | Re: Tip over on spoolup |
When setting up the gov, It looks like I have accidentally changed the swash to 120 reversed (!) That'll teach me not to preflight! |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|