| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Bank switching - which value to send via 3-way switch https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=387 |
Page 1 of 1 |
| Author: | cropduster [ Sun 14. Dec 2014 15:10:57 ] |
| Post subject: | Bank switching - which value to send via 3-way switch |
Hi, I did some search in the forums, but did not get a clear answer, it is probably very easy. I want to switch banks via a 3-way switch (mix0,1,2) on Devo 12. Now, which value do I have to send via channel 5 (I am using RX801 Devo 8 channel receiver) to the RX to trigger bank 0, 1, 2? I understand that I am not actually sending any value that is used within the Spirit, but depending on which bank I activate, the Spirit uses all the configuration connected to that bank. So, I need to tell my devo 12s (running deviation freeware) the value it should send on switch position mix0, 1,2 . Thanks, Michael |
|
| Author: | ZeXx86 [ Sun 14. Dec 2014 15:37:11 ] |
| Post subject: | Re: Bank switching - which value to send via 3-way switch |
Hi, first from all you have to configure Bank function to Channel 5 in the software. Then you simply can set values in the TX in this way: -100% - Bank 0 0% - Bank 1 100% - Bank 2 |
|
| Author: | cropduster [ Sun 14. Dec 2014 15:42:49 ] |
| Post subject: | Re: Bank switching - which value to send via 3-way switch |
Thanks!! |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|