Hey guys,
I was excited to see an update to V3.0 yesterday, so I duly went through the procedure for downloading and updating the firmware and software, everything seemed good. This morning, the sun was shining, I hadn't caught 'Covid19' the previous night, and all was I thought good !
Imagine my surprise when, after starting my Trex700 gasser and warming it up, I took off and engaged' stabilisation. The leading edge of the swashplate tilted up 10 or 15 degrees and tilted to the left almost as much,
I almost crashed ! !
The bas setup is exactly the same, all that changed was the software/ firmware, what ever i tried i wasn't able to adjust this effect out, as soon as stabilisation was engaged the swash tilts.
So I have had to de-install V3.0 and reinstall V2.8 which I know to be safe.

BE CAREFULL UPDATING,
Yours, nervously.
Steve E

Hello,

there is nothing wrong. It is important to check everything always after update, before flying.

Please check this thread for solution:
viewtopic.php?f=20&t=3859

_________________
Spirit System developer

Please, accept my apologies, there is nothing wrong with the programs, as suggested I calibrated my geolink now all seems good,
Thanks, as ever, for the quickest of technical help in the rc business !
Regards,
Steve E

You are welcome.

Please check this page: http://manual.spirit-system.com/index.p ... ise_Rescue

There is new section "Bench testing" that is describing how to verify if everything is OK right before flight.

_________________
Spirit System developer